| Mechanical Properties | | |
| Connection Force | After connecting and disconnecting using standard plug gauge 3 times. | 0.5~2.0Kgf |
| Disconnect Force | After connecting and disconnecting using standard plug gauge 3 times. | 0.6~2.0Kgf |
| Terminal Strength | Apply a static load of 0.1N/m (1kgf/cm) to the tip of the terminal for 1 min in any direction. There shall be no damage to the terminal such as cracks, looseness or play. Electrical and mechanical characteristics shall be satisfied. | Satisfied |
| Electrical Properties | | |
| Contact Resistance | Measured at small current (100mA or less) at 1000Hz. | 40m MAX |
| Insulation Resistance | Apply a voltage of 100V DC for 1 min to specified portions. | 100M MIN |
| Dielectric Strength | Apply AC 100V rms (50~60Hz) for 1 min with trip current of 0.5mA to specified portions. | Without damage to parts, arcing or breakdown etc. |
| Durability | | |
| Solderability Test | Dip terminal top 1mm in solder bath of 2505 for 50.5 seconds. | Solder wetting time 3 sec; Soldering area 75% |
| Resistance to Soldering Heat Test (Reflow) | Conditions: Preheat to 180 (120s), Peak temp 2605 ( 20s). | No deformation of case or excessive looseness of terminals. Electrical characteristics satisfied. |
| Resistance to Soldering Heat Test (Hand Soldering) | Bit temp 3305, application time 30.5 sec. No excessive pressure on terminal. | No deformation of case or excessive looseness of terminals. Electrical characteristics satisfied. |
| Humidity Test | Store at 402 and 90%-96% RH for 96 Hr, then maintain at standard atmospheric condition for 1 Hr. | No damage on appearance. Mechanical and electrical characteristics satisfied. |
| Heat Test | Store at 702 for 96 Hours, then recover at room temperature for 1 Hr. | No damage on appearance. Mechanical and electrical characteristics satisfied. |
| Cold Test | Store at -253 for 96 Hours, then recover at room temperature for 1 Hr. | No damage on appearance. Mechanical and electrical characteristics satisfied. |
| Life Test (No Load) | 10000 cycles (insertion/extraction) at a speed of 10 to 25 cycles/min. | Satisfied |
| Life Test (With Load) | 10000 cycles (insertion/extraction) at a speed of 10 to 20 cycles/min under rating condition (non-inductive load). | Contact Resistance 0.1; Disconnection Force 0.8 to 2.0N; Mechanical and electrical characteristics satisfied. |
| Temperature Cycling Test | 5 cycles of specified temperature conditions, then 30 min room ambient. | No deformation or cracks in molded part. Insertion & Extraction Force: 3 to 20N. Contact Resistance: Max. 30m. Insulation Resistance: Min. 100 M. Dielectric Withstanding Voltage: 100VAC/min (between terminals). |
| Cold & Heat Shock Test | 5 cycles of specified temperature conditions, then 30 min room ambient. | No deformation or cracks in molded part. Insertion & Extraction Force: 3 to 25N. Contact Resistance: Max. 30m. Insulation Resistance: Min. 100 M. Dielectric Withstanding Voltage: 500VAC/min (between terminals). |
